LED Waterproof Batten 40W – 6,800 Lumen – 4000K – 120 cm – DALI-2

This waterproof LED batten of 120 cm and 40W delivers 6,800 lumens with an efficiency of 170 lumens per watt. It is suitable for car parks, warehouses, workshops, stables, technical rooms, basements, bicycle sheds and canopies, and easily replaces old fluorescent fittings.

The housing is dustproof and waterproof according to IP65 and impact-resistant according to IK08, with an opal plastic cover on an aluminium base. The end caps are held by screwless clamps, so you can quickly open the fitting during installation to connect the wiring.

Light colour and light

The light colour is 4000K neutral white, a bright and pleasant working light in which colours look natural, the most popular light colour for workspaces. The light is spread widely over an angle of 120 degrees, so walls and corners are also well lit. The colour rendering is higher than CRI 80.

Driver and connection

The driver is built in and is therefore simply included. You don't need to order a separate driver or power supply: you connect the fitting directly to the 230V mains. This version contains a Lifud driver. The driver is dimmable via DALI-2, so you can include the fitting in a lighting control system and control it per lamp or group. Thanks to the 2.5 mm² through-wiring you can easily link several fittings into a long light line, so you only need to run one supply cable to the start of the line. Have the electrical connection carried out by a qualified electrician.

Technical specifications

In short: power 40W, luminous flux 6,800 lumens, efficiency 170 lm/W, light colour 4000K, colour rendering CRI >80, light distribution 120°, length 1221 mm, IP65, IK08, driver built in (Lifud), dimmable DALI-2, through-wiring 2.5 mm², 5-year warranty.

Frequently asked questions

Is the driver included?

Yes, the driver is built in. You connect the fitting directly to 230V; no separate fluorescent tubes or starters are needed.

How do I link several fittings together?

You connect the supply cable to the first fitting and continue from there to the next one via the through-wiring in the fitting. Have this done by an electrician and take the maximum load of the circuit into account.

You can download the datasheet on this product page.