België 
Denmark 
Deutsch 
Español 
Finland 
Français 
Nederlands 
Sweden 
Connection connector strip-to-cable 10 mm for LED strips. Install without soldering.
-
3 days -
2 years -
15.3 x 14.3 x 4.8 mm -
AFTER
- Categories:
- LED Strip Accessories
With this click connector you connect the start of the strip to a cable to the power supply or controller, without soldering. This version is suitable for single-colour SMD strips 10 mm wide.
What to look out for?
Always choose a connector with the same width and type as your strip: a COB strip has different connectors than an SMD strip, and an RGB strip has more contacts than a single-colour strip. Cut the strip at a cutting point, slide it into the connector until the contacts sit properly on the copper pads, and close the clip. Mind the plus and minus. The connector works on low voltage (12V or 24V) and belongs between the LED power supply and the strip, never on 230V.
Frequently asked questions
Do I need to solder?
No, this is a click connector that you install without soldering.
| Dimay Sku | DM95489 |
|---|---|
| Light Color | K3000 |
| Dimensions | 15.3 x 14.3 x 4.8 mm |
| Delivery Time | 3 days |
| Voltage (V) | 12V |
| Housing Color | N/A |
| Light Source Included | No |
| Ambient Temperature (°C) | -20°C to +40°C. |
| Lifespan (hours) | 17,000h |
| Warranty | 2 years |
| IP Rating | AFTER |
-
S-S cable connector 10 mm for LED strip€0.94 €0.78 -
S-S connector 10 mm for LED strip€0.65 €0.54
