S-S cable connector 10 mm for LED strip

This connector joins two pieces of 10 mm wide LED strip without soldering. A short cable sits between the two clips, so you can turn a corner, bridge an obstacle or continue a piece of strip a few centimetres further on. The connector is made for a single-colour LED strip of 10 mm width and for low voltage (12V). Before ordering, check the width of your strip and the number of copper contact pads at the end, because only then does the connector make good contact on every pole.

You need one connector per joint: if you want to split or join a strip in three places, order three. Always cut the strip on the marked cutting line, push the end into the clip up to the stop and check that the plus and minus markings on both pieces of strip are on the same side.

The connector is suitable for indoor use, for example under kitchen cabinets, in a cove or behind a wall unit, and not for outdoors or damp rooms without extra protection. The dimensions are 15,3 x 14,3 x 4,8 mm. No LED strip, power supply or light source is included; this is only the connecting piece. Not sure which connector fits your strip? Email us at info@dimay.com with the width and type of your strip and we will check it for you.